Flowstand II for Tablets / Phablets
Description
**Fts-02A** 'Flowstand Ii' -------------------- Note: Unfortunately Iinitially Uploaded A Slightly Larger Version Of Fts- 02A_C. If You'Re One Of Those Guys Who Downloaded The Complete Parts Straight After This Was Released And Found The End Pivot Piece Didn'T Fit, Download And Re-Print Fts-02A_C Only - The New Version Should Fit. --------------------- Hugely (Functionally) Improved Version Of [Fts-01A](Http://Www.Thingiverse.Com/Thing:261223) - Sharing The Same Profile, But With Strengthened Arms, Fold-Flat Feature And Sliding Brace. Version History: Current Upload = Original Build Particulars: 1. Print Two(2) Of Fts-02A_A And One(1) Of Fts-02A_B & Fts-02A_C. Suggested Makerbot 2 Build Placement In One Of The Above Pictures. 2. Snap Fts-02A_C Onto The End Of Both Arms, Noting The Orientation Of Fts-02A_C (The Contour Of The Unit Follows The Contour Of The Ends Of The Arms). 3. Then Snap Fts-02A_B Into Openings Of Both Arms (Best Done In The Middle Of Openings - You May Want To Use A Flat-Bladed Screwdriver To Pry The Opening Apart). Total Build Time On Standard Res On Makerbot 2 = ~1 Hour. Commonly Available 6Mm Dome Stick-On Feet Will Just About Fit On The Legs / Rear Pivot.
Statistics
Likes
9
Downloads
0