Boosted Board V2 56T Flywheel pully
Description
This Is A Pulley For The Boosted V2 Board. It Is 56T (56 Teeth) Same As The Stock Gear In Teeth And Size. No Special Belts Needed. Easy Swap Out! If You Put 97Mm'S On The Dual+ Should Get *About* 24-26Mph With A Slight Loss In Breaking And Hill Climbing Toque This Is My First 3D Object! I Based It Off Of The Https://Eboardhacks.Com/ Evolve Pulley So I Have Made A Few Changes: - Undersized The Inner Large Bearing Chase By .003 For A Tight Pressed Fit Like The Stock Gear - Fixed The Flywheel Spleen/Prongs To Fit Without Dremeling To Fit I Print In 100% Solid Abs. I Have About 50 Miles On Them As Of Now.
Statistics
Likes
18
Downloads
0