17mm Hex Hub for 6mm shaft motor.
Description
Wanted To Reduce Weight From Using Brass/Steel Hubs, So Printed A Beefed Up Asa Version For 6Mm Shaft Motors On A <B>Low Speed</B> Robotics Project. Printed In Abs/Asa At 100% Fill To Maximise Strength. Holes For M3 Grub Screws And M4 Wheel Bolt Will Require Tapping Or A Little Force To Get Screws To Tap Themselves. 6Mm Shaft And 17Mm Hex End Should Be A Tight Fit. If To Tight Maybe Under Size By A Small Margin, Or Reduce Over Extrusion To Get A Good Fit. <B>If You Like Or Use This Please Send Me A Little Support, Just A Pound Or Two (Or Dollars Etc) At [Paypal.Me/Mettauk](Https://Paypal.Me/Mettauk/ "Help Me") Thank You</B>
Statistics
Likes
29
Downloads
0