Succulent dome
Description
Something To Decorate Your Desk :) Dome: Polysmooth™ Transparent Printer: Mass Portal Pharaoh Ed15 (0.6 Nozzle) 0.2 Layer Height 0.75 Extrusion Width 210˚C / 60˚C Vase Mode 40Mm/S Printing Speed (With Cooling Overwriting) (Lower The Jerk And Acceleration Of Your Printer If Its A Commun Cartesian Printer :) ) I Poor Alcohol Inside To The Top (Like A Cup) For 3-5Min, I Then Polished The Outside Faces With The Polysher For 3*10Min (5Min Drying With A Fan). Base: Polywood™ As For The Base I Used The Same Printer, Polywood™ Profile With Over Extrusion, Sand It Down Slightly With A File Then Use A Lighter To Even Out Everything. The Succulent Is Not From Me But I Dont Find The Link Anymore So I Post The Stl I Downloaded :( It Was Smth Like This : Https://Www.Thingiverse.Com/Thing:2314536 Hope That Help :)
Statistics
Likes
334
Downloads
0