Tool plate for Magnetic Mounting plate Thingy (25mm conduit)

Description

This Is A Base Plate For Tools. Check Out My Magnet Mounting Plate Thingy (25Mm Conduit) To Distinguish The Magnet Holes From The Rampa Nut Holes. Link: Https://Www.Thingiverse.Com/Thing:1675690 There Is 0,5Mm Space Between The Two Part, Except For The Bottom Of The Rest Pin. You Can Use A Tool (Can'T Refer To "The" Tool At The Moment) To Let The Magnets Stick Out A Bit, So That The Holes On The Side Allign 100%. The Holes On The Side Allign With The Rampa Nuts In The Mount Plate. The 5 Rampa Nut Holes In The Middle Are For Something Like A Dual E3D Mount Like Https://Www.Thingiverse.Com/Thing:1222291 Upper Holes For The Ajustment Bar Are A Lineair Pattern Of 25Mm. Lower Holes (4) Have The Following Distance 6,75Mm From The Middle And The 2 Holes On Each Side Are 16,75Mm Apart From Eachother. (See Messy Picture) P.S. Will Make A Tool To Push In The Magnets And Let Them Stick Out 0,4 / 0,3 / 0,2 / 0,1Mm

Statistics

Category

Tags