FT5 Accurate Adjustable Z Endstop

FT5 Accurate Adjustable Z Endstop

Description

This Is A Much More Accurate Z Endstop! You'Ll Notice How Accurate/Stable It Is Immediately! Watch It In Action: Https://Youtu.Be/Tf2Z4Ekhi4I See The Video At The Time: 3:57 To See The First Version I Made: Https://Youtu.Be/Jwi-Znhx8Co?T=237 It'S Very Simple Just Two Screws, The Lower Screw Is With Flattened End, The Upper Screw Is With Sharp End (Wood Screw). You Need To Change The Endstop Logic In The Firmware To Nc (If It'S Not Nc Already). You Will Be Using Two Pins Only Signal (S) And Negative (-). Don'T Use The Positive (+) Pin, We Don'T Need The 5 Volts. Before Wiring It, Adjust The Upper Screw So It'S Barely Touching The Lower Screw (For The Best Sensitivity), You Can Use A Multimeter To Make Sure If It'S Working As It Should. * Depends On The Bed Height From The Plat, I Provided Two Parts To Chose From (Files 1 And 3). This Is Not The Final Version, It'S More To Show You The Principal. *The Slower You Home Z The More Accurate It Is (This Applies For Any Z Sensor).

Statistics

Likes

10

Downloads

0