Micromake C1 COREXZ conversion
Description
Micromake C1 Corexz -------------------------------- These Are All The Parts You Need To Convert Your Micromake C1 To The Corexz System. This Conversion Eliminates The Racking Motion Of The X-Axis Inherent To The H-Bot System. As A Result You Will Get True Circles And Not Elliptical Circles :) Top And Bottom Layers Will Also Be Nicely Closed, No More Annoying Space Between The Filament Lines. Please Note That The Effector Is Designed For A Mgn9H Linear Rail (310Mm). Make Sure You Read The Firmware Notes Below Before Doing This Conversion, There Are Some Cables You Need To Switch! Firmware Notes: Notice! --------------------- This Firmware Is Intended For The Micromake C1 Corexz Conversion. It Will Not Work Correctly With A Stock Micromake C1! For This Firmware To Work Correctly With Your Converted Micromake C1, Please Switch The X And Z Stepper Motor Cables On Your Main Board. The Original X Motor Plug Needs To Go Into The Z Motor Socket. Subsequently The Orgininal Z Motor Plug Needs To Go Into The X Motor Socket. This Firmware Uses 64 Step Resolution. You Need To Switch Your Main Board Resolution By Removing The Ms-1 Jumper From The Main Board. The Included Image Shows You Where To Find The Ms-1 Jumper. After The Above Steps, Upload This Firmware To Your Board And You Are Done.
Statistics
Likes
26
Downloads
0