Light Switch Holder for BMW vehicles
Description
This Is An Accurate Replica Of The Light Switch Holder That Is Found In The Bmw 5-Series Sedan. I Included The Files For Right And Left Side Printing To Accommodate For Smaller Print Surfaces. I Also Slightly Widened And Reinforced The Vertical Bar Between The Two Switches, As I Have Found This Is A Common Failure Mode. When Printing As Two Pieces The Tabs Will Insert Into Each Other To Keep The Piece From Flexing Once Installed. I Recommend A Little Glue On The Tabs For Extra Reinforcement. This Piece Requires A Little Sanding Around The Tabs Post Print To Get A Nice Fit. No Scaling Necessary, The Screws All Locate Perfectly.
Statistics
Likes
13
Downloads
0