EZABL Case for frame mounting

Description

I Have The Creality Cr10 S5 And Tdh'S Ezabl (Automatic Bed Leveling) Kit. I Wanted A Way To Mount It To The Frame With T-Nuts So I Created This Case. The Original Case Has 4 Holes But I Couldn'T Find A Good Place To Mount It. I Have The Direct Wire Version. Per Tim'S Instructions, To Remove The Circuit Board From The Current Case You Need To Heat Up The Bottom Of The Case With A Heat Gun Until The Hot Glue Softens And You Can Remove The Circuit Board. This Worked Fine For Me And Softened Up The Sides Of The Case Too So I Could Sort Of Peel Them Down To Get A Better Grip On The Board. I Assume No Responsibility If You Damage Your Circuit Board Doing This. Just Don'T Over Heat It And You Should Be Good To Go. It'S A Tight Fit For The Board So I Didn'T Even Bother Using Hot Glue To Secure It In The New Case And Since It'S Mounted On The Frame There Is Very Little Movement. I Made The Inserts For The Lid Screws Pretty Big But The Actual Holes Small So You Should Be Able Find 2 Tiny Screws To Secure The Lid. I Actually Used 2 Small Wood Screws. There Is Plenty Of Room To Drill Them Out Bigger If Need Be. All The Wires Exit Around The Lip Of The Case Instead Of Holes On The Side. Just Place It On The Frame Where You Want It And Secure It With T-Nuts. If You Need T-Nuts You Can Get Them From Amazon. I Used The M5X8 But You Probably Could Use Longer One Too. M5X10 10.9 Alloy Steel Button Head Hex Socket Cap Screw Bolt Https://Www.Amazon.Com/Gp/Product/B01Axut6Va/Ref=Oh_Aui_Detailpage_O04_S02?Ie=Utf8&Psc=1 M5X8 Button Head Hex Socket Cap Screw Bolt Black Https://Www.Amazon.Com/Gp/Product/B01C3Lhmsg/Ref=Oh_Aui_Detailpage_O04_S02?Ie=Utf8&Psc=1 10X6X4Mm 20 Series Aluminum European Hammer Headdrop In M5 T Nut Slot Https://Www.Amazon.Com/Gp/Product/B01D83Gz7C/Ref=Oh_Aui_Detailpage_O04_S03?Ie=Utf8&Psc=1

Statistics

Category

Tags