Logitech C270 Camera - Bed Mount for FLSun i3 (2017 edition)

Description

I Couldn'T Find A Bed Camera Mount For The Flsun I3 (2017 Edition) That Didn'T Bounce And Shake When Streaming And Taking Timelapses. I Built A Heavy One That Uses The Existing Holes For Slider Bearing Block. The Clip Also Provides Some Additional Rigidity. I Made The Holes For The Bed Mount A Little Larger In Case There Is Some Variance Between The Hole Locations On The Acrylic Versus Aluminum Upgrade Beds. At Minimum You Should Print The Sidebedmount.Stl And Riser.Stl. These Can Be Mounted Together. If You Want Additional Flexibility, You Can Print Outrigger.Stl And Shortoutrigger.Stl To Add Another Joint In The Mix. The Riser Is A Standard C270 Camera Mount. I Used A M3 X 25 Bolt To Connect The Two. It'S A Little Snug On Purpose So The Camera Stays Fixed In Place. This Thing Was Designed To Be Able To Stay Within The Boundaries Of A Lack Enclosure So Long As The Walls Are Mounted At Least Flush With The Outside Of The Legs. You Will Need: 1 M5 X 16 Bolt To Connect The Riser To The Bed Mount. 1 M5 Nut 2 M4 X 20 Bolts To Replace The M4 X 15 Bolts That Currently Hold The Bearing Blocks To The Bed. 2 Wide Washers For M4 Bolts. Reuse The M4 Nuts For The Bed Mount. If You Want To Use The Extentions (Outrigger.Stl And/Or Shortoutrigger.Stl) You Will Of Course Need Extra Bolts And Nuts. For A Video Of The Bed Mount Being Printed Using The Bed Mount To Record (Whoa! That Just Blew My Mind!) Check This Out: Https://Www.Youtube.Com/Watch?V=6Sumtps4A4S

Statistics

Category

Tags