Anet A8 Titan E3D V6 direct extruder mount V3
Description
<H5>Based On The Original Prusa I3 Titan Extruder Assembly.</H5> If Your Going For Print Speed On An I3 Style Printer This Mount Is A Good Place To Start. Https://Www.Youtube.Com/Watch?V=Clixtez3Fja - Corrected Spacing For Anets Smooth Rods ( 46,3Mm Center - Center - Injection Molded Holders ) - Added Huge Z Offset To Bring The Assembly High Enough For The E3D V6 While Not Wasting Z Height, Actually You Will Gain About 10Mm Z Height Vs The Stock Anet Assembly. - I Highly Advice Against Using Igus Bearings Like I Did First, They Dont Work Properly On The A8 Smooth Rods And Will Wear Quickly. Reach Around Fan Duct Only Fits The Smallest Pancake Stepper, So You Need To Run A Different Controller, The Standard Anet Board Cant Drive 1.7A Steppers. Doing This Conversion You Reduce The Extruder Weight By 300G !
Statistics
Likes
64
Downloads
0