DreMill 3D printer to mill adapter with adjustable run out
Description
This Is So I Can Add A Dremel 3000 To My Printer To Do Some Milling And Engraving. The Three Bolts Up Top Are To Adjust Run-Out At The Bit End. Take Off The Nose Nut And Thread A Dremel Into The Print After You Have Added The Bolts, There Are Threads Built In. Also Has A Vent/Finger Hole For Locking It To Change Bits. Adjust The Bolts To True Up The Bit. This Is A Work In Progress. I Am Busy As A Whore At A Viagra Convention So I Haven'T Gotten Much Further Than This. The Latest File Has Recesses For Jam Nuts Not Seen Here On The Prototype. Pardon The Crappy Print, I Shifted A Layer But Recovered And I Was So Close To The Finish Just I Tripled The Print Speed And Just Let Er Buck. Fits A Fan Too. Also Fits My Fan Adapter I Published Earlier. Mounting Bolts Will Fit My Machine, Not Sure About You. Designed To Mount On A Flat Plate And Has A Lip At Back To Help Line It Up.
Statistics
Likes
11
Downloads
0