Compact GT2 / 2GT belt clamp FPLC Biomaker
Description
I Needed To Clamp A Gt2 / 2Gt Belt For A Custom Scara Design, With Some Tight Spots. Most Clamps Don'T Run Past A Sprocket, Or Tend To Slip If They Do. I Was Inspired By Idegraf'S Design (Https://Www.Thingiverse.Com/Thing:1247615), But Needed Something More Compact - Hence This Design. There Are Three Versions - Each One Consits Of A Top & Bottom Part. Slim: Has A 0.4 Mm Top Layer, Which Affects The Robustness Somewhat. Thick: Has A 1 Mm Top Layer, If Thickness Is Less Of A Concern & Robustness Essential. Staple: Slightly Different Design, With The Two Pins Being Replaces By Cutouts For Two Standard Office Staples. Just Pushthem Through The Two Halves Once Assembled.
Statistics
Likes
20
Downloads
0