Razor Scooter Motorcycle Style Throttle
Description
Built This Throttle Because My Little One Had A Hard Time Holding The Razor Scooter'S Throttle On For Extended Time, Before Their Hand Began Hurting. I Printed Both Tubes Separately Standing Vertically With Openings Pointing Down And Without Support On The Prusa I3 Using 1,75Mm Pla. Installation Instructions: First Remove The Black Handle On The Scooter, Then Loosen The Allen Lock Screw On The Throttle. Install The Plastic Inner Bushing And Re-Tighten The Throttle In Place So That The Bushing Is Fully On The Handle Bar Shaft. Then Install The Larger Throttle Tube, Taking Care To Use A Flat Blade Screwdriver To Force The Rubber Throttle Inside. No Glue Is Required As This Is Built As A Friction Fit And Easily Undone.
Statistics
Likes
6
Downloads
0