Dobelman D20 of holding
Description
This Is Not A Remix, But Very Much Inspired By Https://Www.Thingiverse.Com/Thing:105296 And Https://Www.Thingiverse.Com/Thing:1610141 Numerical Faces Are Aligned To Be Used As A Countdown Die. The Top Seam Shouldn'T Snag Or Over Hang When Closed. There Is A Little Notch Between 16/20 Along The Edge That Should Help Easily Line The Lid Up. It Was Also Intended To Help Lift The Lid When Opening. However I Found That Sliding The Top Across The Magnets Was Much Better And More Gratifying Than Lifting It Straight Up. Picked Up The Magnets From The Local Michaels. Https://Www.Michaels.Com/Promag-Neodymium-Magnets/10413548.Html .25In - 6.3Mm Printed With Makergeek Royal Purple Abs. I Did Have A Couple Of Minor Splits In My Print. And Used A Thick Abs Slurry As Glue To Hold The Magnets In. Which I Have A Feeling, Since The Magnets Are So Smooth May Pop Out Some Day Soon. Should Have Super Glue'D Em. I'D Love To See This Printed With A Better (Or Better Adjusted) Printer.
Statistics
Likes
15
Downloads
0