Halogen light arm mount
Description
I Had A Pair Of Halogen Lights And An Ac Transformer Which I Used To Add Lights To My Cr 10 Enclosure. I'Ve Been Designing Things For About A Month So It Might Need Some Tweaking But I Was Successful In Printing Them And I Am Using Two Of Them In My Setup. They Provide Light And Heat For Abs Prints. I Can Go Up To 50 C + Ambient Temp But Try To Stay Below 45 To Keep Electronics Happy. To Make One Arm You Will Need A Print Of Each Part (Base,Arm,Light Holder And A Hole Cover) As Well As: 2 X Rubber Washers - I Used 5/16 M8 Rubber Washers, These Are Placed As Shown In The Last Picture. 2 X M3X20Mm And Matching Nuts - To Secure The Light Unto The Light Holder Part. There Are Many Knobs You Can Use But I Printed 2 Of These Https://Www.Thingiverse.Com/Thing:769430 By B_Emme3D. Printing One As Is For The M6 And Resizing Down For One M5. I Epoxied Them Unto The The Following Parts: 1X M5X25Mm Bolt 1 X M6X13Mm Bolt I Put Old Locknuts Under The M6 Head To Lift The Bolt Up To The Brim Of The Knob Before Gluing. Lastly Use 2 Wood Screws To Secure The Base And Use A Drill Bit To Pass Light Cables Through Enclosure And Seal Hole With Hole Cover Stl.
Statistics
Likes
21
Downloads
0