TEVO TITAN CASE Nozzle Storage
Description
I Had 3 Of The Plastic Cases That The Tevo Titan Clone Comes In. I Thought They Would Make Good Storage Containers For My Nozzles, Heat-Breaks And Blocks. 1-V6, 1-Volcano, And 1-Heat Block Insert Should All Fit Into The Container. The Short Shell Insert Can Be Substituted For A Volcano Insert. 2 Tall Shell Inserts Will Fit Top To Bottom In The Case. I Made A Little Tool That Helps To Pull The Inserts Out. It Works Ok, But Could Be Improved Upon. If Anyone Has Suggestions On Improvements, Please Post In The Comments.The Inserts In The Photo Were All Printed @ 15% Infill; 1 Wall; .26 Layer Height, And All The Nozzles Fit Nicely In The Holes. The Nozzle Inserts Are For Standard 7Mm Hex E3D Style Nozzles. The Heat Block Insert Holds 6 V6 Blocks And 6 Volcano Blocks. Mine Are All Clones, Not Sure If This Will Affect The Sizing On Genuine E3D Parts. For The Volcano Low And V6 Low, The Channels Are Level With The Hex Part Of The Nozzle. Volcano Flush And V6 Flush Are As The Name Says, Flush With The Tips Of The Nozzles. The Pull Tool "Vertical", Adds A Cross Section For Support, But This Is Untested As Of Now, Feel Free To Print And Try It.
Statistics
Likes
13
Downloads
0