Tevo Tarantula Dual Blower/Radial Fan Duct for Single/Chimera dual extruder + various BLTouch supports
Description
In My Quest For Silence, I'Ve Moved The Bltouch Out Of The Air Flow Rather Than Just In Front Of The Fan. Here Are Re-Inforced Double Blower Holders For : - Single Extruder - Chimera Dual Hotends As Well As Those Bltouch Support : - Below The Carriage, Embedded Screw Heads (Not Recommended) - Below The Carriage, Embedded Nuts (Allows Maintenant Without Removing The Wheels) - Attached On The 30Mm Fan, But Out Of The Air Flow. **<<< Recommended** File Bltouch_Layer_Fan_4.Stl **If You'Re Looking For A Fast And Easy Way To Attach The Bltouch On A Dual Extruder Head, The Small Corner Piece Is The Way To Go, An Other Alternative Is This One :** Https://Www.Thingiverse.Com/Thing:2396504 This Version Has Modified Ducts, That Prevent From Melting On The Hotends, And A Reinforced Front Bar With A Hole For The Fan. *I'Ve Also Provided A Single Extruder Version* Bltouch Is Attached Using The Spacer Bar, That Replaces The 5Mm Wheel Spacers. I'Ve (Roughly) Remixed This One Https://Www.Thingiverse.Com/Thing:2010315 No To Require To Remove The Nearly 20 Wires That Go Through The X Carriage Plate. **Edit:** A New Version That Embeds The Nuts Rather Than The Screw Heads Is Preferred, As It Won'T Require To Disassemble The X-Carriage Again If You Have To Remove The Bltouch For Maintenance. **If You Intend To Print Abs, Print The Dual Duct In Abs** Or It Will Get Soft And Bend Onto Your Print Due To The 100°C Bed. See It In Action : Https://Www.Youtube.Com/Watch?V=Iqyqsv_8Md0
Statistics
Likes
50
Downloads
0