Nintendo Switch Stand - Tesla Version
Description
Thanks, Jpoel, For The Great [Charging Stand Design](Https://Www.Thingiverse.Com/Thing:2172882)! I Decided To Replace The Zelda Graphic With A Tesla Logo. The "T" Portion Is .4Mm Thick (Two Layers If Printing At .2Mm Layer Height). If You Use A Translucent Material For The Bottom Layers, Then Light Will Shine Through The "T". Pieces Of 1.75Mm Filament Are Used For The Hinge Pins. To Keep The Pins From Sliding Out, I Used A Flame To Heat Up The End, Pressing While It Was Hot To Mushroom The Tips.
Statistics
Likes
11
Downloads
0