Kite Foil
Description
Update 05.07.18 - Added Nut Protection For Front And Rear Wing - Shortened Fuselage -> New Drawing A Hydrofoil Allows Kitesurfing In Very Low Wind Conditions. Unfortunately, They Are Quite Expensive.Therefore, I Decided To Build My Own. I Used For Both Wings An Eppler 817 Profile The Wing Area Is About 600Cm2 / 200Cm2 The Mast Is A Manta 2 Aluminium Mast Buyed Here: Https://Www.Mantafoils.Com/E-Shop/Manta-Aluminum-Mast-Production-Scrap-P59642799 For The Fuselange I Choosed A 20X20 Stainless Steel Square Tube The 3D-Printed Wings Were Covered With Gfk, The Mast-Box Is Also Laminated With Gfk. But Be Aware, Positiv Laminating Means A Lot Of Sanding ! The Board Is A North Freestyle Fish 5`2" The Laminated Wings Are Very Stiff. The Mast To Board Connection With The 3D Mast Adapter Is Not As Stiff As I Wished. Perhaps A Laminated Mast Base Plate Is The Better Choice.
Statistics
Likes
257
Downloads
0