MeGaTroN Cooler Fanduct Tevo Tarantula w BLTouch Remix
Description
Update 9/25/2017: Fixed Height Of The Bltouch Mount Issue. If You Printed The Orginal Use A 5Mm Spacer To Correct The Z-Height Of The Sensor. Offsets For The Firmware That I Have Currently Are As Follows: X -34 Y -5 Z-Offset -1.20 (This Is What I Have Worked Out For Mine, But Each Is Different So Please Go Through The Full Process To Find Your Z-Offset. Loved This Design By Paul0 And Needed A Bltouch Mount. I Remixed It In Tinkercad By Using The Orginal Megatron Fan Duct And The Orginal Bltouch Mount And Merged Them Together. When Installed The Lowest Point Of The Fan Ducts Should Be About The Same As The Pin On The Bltouch When It Is In Stored State. I'Ll Post Offsets As Soon As I Have It Installed On My Tarantula. Supports Are Not Needed To Print.
Statistics
Likes
8
Downloads
0