Mono Price Mini Select ED3 V6 Zero offset mount
Description
****Note: 10/03/2017 I Recently Acquired A Silicon Sock And Installed It And Noticed There Isnt Enough Clearance For The Sock To Make It Past The Fan, I Am Working On A Redesign Of The Front Clamp And A Better Solution For Layer Cooling Once Done I Will Post Up The New Files.**** This Is A Full Replacement Mount For The Ed3 V6 Hotend Upgrade For The Monoprice Select Mini Printer. This Mount Offers 100% No Offset From Original Position. This Mount Requires You To Reuse The Carriage Bearings Or Purchase New (They Are Easily Re-Usable). The Mount Requires No Additional Hardware, Other Than A Zip Tie. To Use This Mount, Remove The Endcap From The X-Axis, Slide The Belt Out Of The Original Mount, Remove The Original Mount. Put Reused Or New Bearings In The New Mount, Slide The Mount On. Center The Mount On The X-Axis And Zip Tie The Belt To The Mount Using The Provided Zip Tie Mounting Area. Trim The Zip Tie Once Tight (Needs To Be A Small Sized Zip Tie To Fit). The Bolts From The Old Mount Are Your New Front Clamp Mounting Bolts, Youll Need The 2 Square Nuts From The Old Heat Sink Too (The Ones From The Front With The Set Screws In Them Work, Or You Can Pound The Two On The Back Out) Put The Square Nuts In The Provided Square Holes On The New Carriage, Place The Ed3 Mount In The Carriage, Screw The Front Clamp On To Secure The Mount, Screw The Fans On, The Layer Fan Clips On And Clips Off Easily. The Instructions Are As Good As I Can Get Without A Full Tutorial, But If You Have Any Questions Feel Free To Contact Me On One Of The Mp Mini Facebook Groups, My Name Is Buddy. This Mount Requires Zero Supports To Print! **Orientate The Parts As Shown On The "Print Bed Layout" You Can Also Download Just That File** The Full Mount Stl File Is For Visual Purposes Only, Do Not Attempt To Print It! Enjoy!!!
Statistics
Likes
26
Downloads
0