DJI Inspire Gear 360 (or any camera) Mount

Description

This The Mount That I Designed For Placing A Gear 360 Camera (Or Any Camera For That Matter) Onto A Dji Inspire 1. I Don'T Know Much About Cad Programs, So I Used Www.Tinkercad.Com To Make A Very Basic Model. On The Back Of The Inspire There Is A Cover Plate, This Model Will Replace That Cover Plate. You Will Need 4 M2X6Mm Cap Head Machine Screws. I Doubt You Will Be Able To Find Any At Your Local Hardware Store. They Usually Don'T Carry Anything That Small. But You Can Find Them On Amazon, And This Is What I Ordered, Https://Www.Amazon.Com/Gp/Product/B014Oo5Kqg/Ref=Oh_Aui_Detailpage_O01_S00?Ie=Utf8&Psc=1. The Stock Screws Are To Short, You Will Need To Use 6Mm Long Screws. I Wouldn'T Go Much Longer Than That For Fear Of Damaging The Back Of The Inspire. This Was A Difficult Print For Me. I Used Abs, With A Lot Of Infill In Order To Make A Strong Mount. I Found That The Best Way To Print This (At Least For My Printer) Was To Print It With The Mount On The Top Side Of The Plate, With The Plate Facing Down On The Bed. You Will Need To Use Supports In Order To Print The Plate Properly. I Used A Square Support Pattern With A Density Of 40%, And It Was Difficult To Get Out. But With A Little Patients, A Pair Of Small Needle Nose Pliers, And A Pair Of Side Cutters I Was Able To Get It Out. I Also Found That I Had To Use A Small Xacto Knife To Widen The Screw Holes On The Inside Of The Plate So That They Would Match Up With The Screw Stems Located On The Back Of The Inspire. I May Enlarge Them In The Model At A Later Time, And If I Do I Will Post The Updated Stl File. It Could Also Be My Printer That Caused This Issue With The Screw Holes, So Your Results Might Vary. I Also Used The Gopro To Tripod Mount Designed By Kelly Egen (Https://Www.Thingiverse.Com/Kellyegan/About), And That Can Be Found Here (Https://Www.Thingiverse.Com/Thing:2062243) As A Side Note, The Stock Inspire Case Will Need To Modified Slightly If You Intend On Leaving This Bracket Installed On The Inspire. I Just Took A Knife And Cut Out The Necessary Area Needed. I Remove The Gopro Tripod Before Placing The Inspire Into The Case.

Statistics

Category

Tags