IKEA Lack Table Stacker and Raiser (No Screws needed)

Description

#Status + ~~First Test Print Is Running, I Will Update Tomorrow~~ + ~~First Test Print Was Successfull, Uploaded V2 To Use Less Material~~ + Thought Wrong, You Need At Least Two Times V1 (Vertical Aligned) Otherwise Its Not Stable, But Then It Works Fine. The Other Two Can Be V2 To Use A Bit Less Material #Target: + To Stack 2 Ikea Tables For A I3 Plus Enclosure. (As They Don'T Fit Over Each Other With The I3 Plus Inside) + It Needs No Screw And Hold By Itself + About 2Mm Tolerance Because Ikeas Doesn'T Care About Precision ;) + 4 Of Them Should Be Printable At Once On The I3 Plus

Statistics

Category

Tags