E3D V6 Mount For Tronxy P802
Description
I Upgraded To An E3D V6 And Made This Mount And Part Cooling Duct For It. I'Ve Been Using This Design For Several Months Now. The Only Thing That Is Relatively New Is My Using Of Printed Bushings And The Bushing Holders I Made. The Part Cooling Duct Is A Few Versions In And Works Well. It Is Wide And Rides Low So You Will Need Some Low Profile Bed Clips Like I Have Posted Here. Https://Www.Thingiverse.Com/Thing:2536787 I Do Not Have Any Provisions For Bed Level Sensors And I Have No Plans On Doing So As I Rarely Have To Mess With Leveling My Bed Once I Have It Adjusted. I Just Use A Measurement Jig To Check My Z Height On Each Side After Homing And Rarely Have To Adjust And That Only Takes A Few Seconds. Https://Www.Thingiverse.Com/Thing:2538266 The Fan Guard I Am Using Is A Great Clip-On Guard I Found At Https://Www.Thingiverse.Com/Thing:1264041 A Bowden Coupling Clip Is A Must. I Used Https://Www.Thingiverse.Com/Thing:1330497 I Really Like My E3D V6 By The Way. It Is Definitely Better Than The Poorly Made V5 Knockoff That Came With The Printer. - Update: 10-6-2017 I Created A New And Improved Cooling Duct That Isn'T So Big And Ugly. Https://Www.Thingiverse.Com/Thing:2572490 I Also Added The File Here As Well.
Statistics
Likes
15
Downloads
0