Arduino ProMicro Case
Description
This Is A Simple Snap-Into-Place Case For The Arduino Pro Micro That Protects It From Scratches, Drops, Etc. It'S Just A Single Piece With The Inner Dimensions Of: (37.21Mm X 3.5Mm - 4 X 18.6Mm) And Outer Dimensions Of (38.53Mm X 4.5Mm X 20Mm). It Can Be Resized To Fit Other Boards Like The Digistump. Whance The Arduino Is Snapped Into Place It Won'T Fall Out (Assuming The Print Is Good And The Right Arduino Is Used). Also I Seemed To Get The Best Fit When I Used No Support Material Since The Arduino Will Slide In Better. When The Arduino Is Inside The Case Not All Gpio Pins Are Accessible. !! It'S Hard To Get The Arduino Out Whance It'S Inside So You Might Have To Breake The Case In Order To Get The Board Out. For Me The Print Takes About 5 Min On Median Quality. Have Fun With It!
Statistics
Likes
14
Downloads
0