3x 18650 Holder
Description
This Is Based On Https://Www.Thingiverse.Com/Thing:2165589 By Tapion This Is A Simplified Design Of The Above Mentioned Battery Case. What This Does Is Allow You To Print 2 Of This Object. Both Pieces Can Be Used As Tops Or Bottoms. I Left An Approx. 1Mm Gap So I Can Tell If Batteries Are Inside Before Picking It Up. You Can Also Just Print One Off, And Use It So Your Batteries Aren'T Rolling Around. Its A Good Idea To Sand A Little Bit Inside The So Your Material Is Not Scratching Your Battery Casing, But That Depends On How Good Your Printer Can Print. I Have Only Printed This In Pla, But I Don'T See Why Abs Wouldn'T Work.
Statistics
Likes
15
Downloads
0