Z Height Jig
Description
This Measuring Jig Fits Between The Top Of The Z-Motor Mounting Plate And The Bottom Of The X Mounts. When It Fits About The Same On Both Sides You Should Be Good To Go! -Alternatively You Could Make Two Of These And Lower Your Z Until It Bottoms Out On Both. My Printer As It Is Setup Up Currently Rarely Needs Any Adjustment If The Bed Is Well Leveled Once. I Just Do A Quick 4 Second Check With The Jig After Homing And About 10% Of The Time I May Need To Turn A Z Motor A Click Or Two. Good Enough For Me! I Feel I Should Note That One Simple Thing That I Changed On My Tronxy P802E That Made A Big Big Improvement On Getting A Consistent Bed Level Was To Replace The Horrible Acrylic Bed Undercarriage With A Solid Aluminum One. Https://Www.Thingiverse.Com/Thing:2545713
Statistics
Likes
212
Downloads
0