Minecraft Torch - Sliding Battery Door
Description
<Iframe Width="560" Height="315" Src="Https://Www.Youtube.Com/Embed/Z9T3Lug5Fn4" Frameborder="0" Allowfullscreen></Iframe> New Design - Shorter With Sliding Battery Door! This Is Designed In Fusion360. Uses 2 Aa Batteries And Flickering 3Volt Candle Lights. Use Clear Pla For The Torch Top. Pla For The Bottom. Print It With The Battery Door In Place, There Is Enough Of A Gap To Remove The 2 Parts After Printing. If Your Printer Cannot Print A Good Clean First Layer You Will Have To Print The Body And The Battery Door Separately. For The Top Of The Torch, I Print With 2 Outside Layers And Little Infill, Just So The Torch Top Can Be Transparent. You Could Probably Use White Filament And It Would Work. For The Battery Holder, I Ordered And Used This Https://Goo.Gl/B8Jrmy The Torch Light Top Is Made With Flickering Candle Lights. I Rip The Lights Apart To Scavenge The Leds. Wire Them Up In Parallel To The Battery And Hold The Square Led Part In Place With A Bit Of Hot Glue. You Could Use 1 Or 5 Leds For The Torch Top. Your Choice On How Many Leds To Use. I Used A 12Mm Push Button Switch. Like This One Https://Goo.Gl/Rzftzz
Statistics
Likes
164
Downloads
0