STC1000 Temperature Controller Housing
Description
I Am Making A Mains Powered Heated Bed For My Printer And Needed A Housing For The Temperature Controller. I Designed This To Complement The Look Of My Printer And So That It Would Fit Under The Print Bed, Although It Could Be Used For Any Machine. I Will Stick It In Te Position Shown But You May Wish To Add Some Stick-On Rubber Feet If You Plan To Use It Free-Standing. The Retaining Clips For The Controller Fit Down The Inside Of The Housing From The Back. Push Them Into Place With A Long Thin Object Such As A Needle File. They Can Be Released By Accessing The Release Button With A Needle File Etc. Through The Slots On The Sides. I Printed At 100% Fill As The Walls Are Thin. The Solid Face Is Only 0.2Mm Thick And Is Cut Away After Printing. I Added This Because I Had Difficulty Printing Small Supports And This Makes The Supports Go Right Across The Front Face Of The Part
Statistics
Likes
23
Downloads
0