Shield for LightView Pro Flex magnifier lamp
Description
This Design Is Specific For A Great Little Led Magnifier Light, The Lightview Pro Flex. This Light Is Very Bright And Flexible -- It Is Easy To Position For Close-Up Work. The Problem I Had Was When Using It As A Work Area Light The Lower Edge Of The Light Is Very Bright And Annoying. Also, When Extended Or Turned The Light Can Become Not As Stable As I Would Like. So, I Made A Shield To Block The Side Visibility Of The Light And A Weight To Provide More Stability When The Light Is Extended. The Fit Of The Shield Isn'T Perfect But You Can Use A Hot Air Gun To Mold The Back Edges Of The Shield To Fit Better And To Wrap Around The Area Where The Switch Is Located. I Used Some Redi-Mix Mortar That I Had Laying Around To Fill The Weight Cavity. This Is The Lamp: Brightech – Lightview Pro Flex – 1 Ultra-Bright Magnifier Lamp Https://Www.Amazon.Com/Gp/Product/B01K10Xa1O The Weight Will Print Without Supports. The Shield Requires Supports. I Used S3D With 4 Dense Support Layers At 80% Infill And Also 15% Infill, 1 Base Layer, And No Extra Inflation Distance For The Standard Supports. For The Automatic Generation I Used 1Mm Support Pillar Resolution With A 50Deg Max Overhang Angle. With Care, I Could Remove All The Interior Supports In One Piece.
Statistics
Likes
4
Downloads
0