Offset 90 Degree Angle Screwdriver
Description
I Needed A Screwdriver For Cramped Areas Where A Typical Screwdriver Won'T Fit (I.E. Sewing Machine Plates) So I Designed An Offset 90 Degree Angle Screwdriver Handle For Standard 1/4" Hex Bits. There'S A Small Dimple On The End For You To Apply Pressure Onto The Screw And A 6" Arm To Apply A Decent Amount Of Leverage. I Added A Little Loop For Easy Hanging And Cut Down On Overall Material. It Is Toleranced So That The Hex Bits Fit Snug And Won'T Fall Out Accidentally And The Whole Thing Prints In About Half An Hour. Enjoy!
Statistics
Likes
24
Downloads
0