Power supply 2020 aluminum profile mount
Description
Bracket Intended To Mount A Power Supply To A 20 X 20 Aluminum Profile, Specifically For The Ultimaker 2 Clone Made By Jasonatepaint As It Relies On The Spacing Of The Two Bottom Profiles. I Made This To Be A Tight Fit, So If You Are Unsure About Your Printer Tolerances I Would Recomend You To Scale This On The Xy Axis So That It Increases It'S Size About 0.3Mm On Each Axis. On The Assembly Picture I Show Only One Bracket But You Should Use At Least Two Of This. It Has Holes On One Side That May Or May Not Match The Ones On Your Power Supply And That Are Used To Hold Everything In Place. You Will Need: -Two Brackets -Four 5Mm Screws With T-Nuts -Four Screws That Match The Size Of The Holes On Your Power Supply. I Included My .Ipt Source However Be Advised That I'M Not That Good At Designing.
Statistics
Likes
4
Downloads
0