PCB Agitator using Arduino, small servo & PVC pipe
Description
This Is A Simple Pcb Agitator For Making The Process Of Etching Circuit Boards A Little Less Tedious. The Servo Bracket Is For 20Mm Pvc Pipe And The Servo Is 9G Sg92R 1.6Kg By Tower Pro. The Bracket Fits Snug As Is And Printed With .20 Resolution With Pla @ 15% Infill. 2 X Pvc Elbow 2 X Pvc "T" 3 X 300Mm 4 X 150 Mm (Feet) Misc Wire 1 X Servo (9G Sg92R 1.6Kg By Tower Pro) 1 X Arduino W/ Standard Sweep Sketch Loaded 1 - 3D Printed Servo Bracket Note: Modify The Original Servo Code Found In Arduino Ide "Sweep" Examples To Have A 10 Second Delay In Between Agitation If You Run This Servo Too Long It Will Freeze .. Sample Code Is Attached
Statistics
Likes
7
Downloads
0