Cornelius keg portable tap
Description
I Did Not Like The Plastic Picnic Tap As It Has No Flow Regulation And Just Looks Cheap, Nor Did I Like To Have The Faucet Mounted Directly On The Disconnect As It Stresses The O-Rings, Leaks And Is Wobbly. So I Made Myself This Fancy Device. You Just Mount It With Velcro Tapes And The Party Begins. What It Fits: I Think There Are Two Sizes Of Cornelius Kegs, Taller/Skinnier Ones (Which I Believe Are Pepsi) And Shorter/Wider Ones (Which I Believe Are Coca-Cola). I Only Have The Taller Ones, So This Fits Them (Outer Diameter Between The Rubber Handles Is Circa 210Mm). If You Have The Wider Keg, Please, Measure The Dimensions And Post A Comment, I Will Adapt The Design. I Made The Mount For My European-Type Faucets. The Hole For A Shank Is 24Mm In Diameter, I Dont Know What Diameter American-Type Shanks Are. If You Need Different Diameter, Leave Me A Comment, I Will Adapt It For Your Needs. Attention!: The First Prototype I Made Broke In The Weak Point Right Under The Circular Part. The Reasons For It Breaking Are: I Used Pla; I Used Layer Fan; I Used Unnecesary Force (It Was A Test); My Layer Adhesion Generally Sucks The Design Is Improved Since Then: I Increased The Thickness Of The Circular Part By 30%; I Increased The Outer Diameter Of The Circular Part; I Extended The Parallel Reinforcements Further Up (Not Yet In The Photo) By A Few Mm I Am Sure The Design Is Now Much More Robust, But I Still Recommend Doing As Much As Possible To Strenghten That Area My Suggestions: Use Something Stronger Than Pla (I Used Petg For The Second Prototype); Turn Layer Fan Off For That Part; Overextrude Slightly For That Part; Increase Infill For That Part If Your Slicer Allows It; Increase Nozzle Temperature For That Part; Remain Gentle (Sober) I Also Made A Three-Part Reinforced Version. The Base Is The Same, Only Has Extra Holes For M4 Bolts. The Two Plates Are Printed Flat, So The Layer Orientation Is Much More Suitable. I Only Think You Need This If You Or Your Friends Get Violent When Drunk. You Can Also Use Some Superglue If You Want It To Become A Relict In The Future The Thing Fits 200Mm X 200Mm (Usable) Heatbed Edit: I Removed The Non-Reinforced Version As It Was Not Stiff Enough. The Reinforced Three-Piece Design Should Be Far Enough.
Statistics
Likes
115
Downloads
0