Anycubic i3 mega c270 camera mount
Description
I Made This By Taking 2 Separate Camera Mounts And Horribly Smashing Them Together. It Looks Bad But It Works Well. I Used This I3 Mega Go Pro Mount: Https://Www.Myminifactory.Com/Object/3D-Printer-Camera-Mount-Mainly-For-Anycubic-I3-Mega-34849 And This C270 Mount For The Cr-10: Https://Www.Thingiverse.Com/Thing:2281259 You Might Need To Remove The Bed From The H Plate To Put This Mount On Like I Did But I Did This As My Hands Weren'T Wanting To Co-Operate In Getting The Screws In Without Taking Off The Bed. The File Named "Bottom" Is The Original Bottom Mount From The Edited Bracket And Left Too Large Of A Gap For Me So I Remade It With A Smaller Gap That Might Need To Be Filled With A Couple Wraps Of Tape. I Think This Will Cut Down On Vibrations A Tiny Bit But I Could Be Wrong. Oh And My Camera Was A Little Loose In This Mount Thats Why I Used The Tape On It. This May Or May Not Be Needed Depending On Your Print Settings.
Statistics
Likes
28
Downloads
0