Belt Rack w/ 4-5 Belt Slots
Description
Simple Wall Mounted Slotted Belt Holder For Your Closet. These Work Well With Regular Belts, But Also Slide Belts And Belts That Don'T Have An Opening On The Buckle That Cannot Be "Hooked" As Required With Most Belt Racks/Hangers Out There. Ver1 - A Smaller Footprint, L150Mm X W28Mm X H55.5Mm. Holds Up To 4 Belts With A Strap Width Up To 8Mm, Slots Are 40Mm Long. You'Ll Want To Print This At 50-75% Infill Probably To Make Sure It Has Strength To Take A Bit Of Abuse. Ver2 - A Larger Footprint, L182Mm X W55Mm X H62.1Mm. Holds Up To 5 Belts With A Strap Width Of Up To 9Mm, Slots Are 45Mm Long, Slot Top Cutout Is Also +5Mm Larger (For Maybe A Bit Deeper Buckle). The Entire Top Is Also Angled 5° To Help Prevent The Belts From Slipping Off As Easily If They Get Bumped. Additionally, Between Each Belt Slot On The Bottom Is A Brace To Give The Whole Thing More Rigidity, The Bottom/Top Plates Are A Bit Thicker, Screw Holes Larger And More Reinforced, And It Has An Additional Screw Hole In The Middle Bottom. As A Result Of This Strengthening You Can Get By With A Much Lower Infill Setting, 20-40%. Both Will Turn Out Very Solid And Should Stand Up To Bumping Into It, Pulling Down On It, Etc. Ver2 Is Probably A Bit Overkill. Ver2 Will Take Just A Bit Longer To Print, Most Of It Offset By The Much Lower Infill Needed. Tip: If You Have A Smaller Printbed Base Try Rotating The Object 45° On Your Slicer.
Statistics
Likes
22
Downloads
0