iStick Pico stand
Description
This Is Just A Simple Stand I Designed In About An Hour. It Keeps My Mod From Constantly Falling Over Its Side. It Can Hold An Istick Pico Or Other Similar Mods Safely On The Desk. **Features:** - Reversible, As All Things Should Be - Minimum Material Required (11-14G) - Very Stable - Easy To Print - Lots Of Clearance, In Case Your Mod Has A Sleeve - Can Be Customized At: Https://Cad.Onshape.Com/Documents/B33Cb2Ed71Ba0577A1Ed1168/W/C7E02266D760Dfef2Ab87116/E/9E84B5Bd9155C11D2405Ccff - **Tested** **Instructions:** Printed In Pla, 15% Infill, No Rafts Or Support. I Think It Took About 40 Minutes. **Design Notes:** Not Very Pretty And Could Use A Bit Of Work On The Fit And Curves. I Took Some Mod Measurements And Eyeballed The Radius, Then Added About 1Mm Of Clearance. I Still Don'T Know How To Design Symmetric Organic Objects In Onshape, So The Curves Were Done With Fine-Tuned Fillets. I Would Add Some Chamfer Or Fillet On The Inner Usb Top Edges, But I Was Afraid It Wouldn'T Print Properly As The Wall Is Already Pretty Thin.
Statistics
Likes
15
Downloads
0