Philips Diamond Clean toothbrush wall mount
Description
A Wall Mount For The Philips Sonicare Diamond Clean Toothbrush. No Need Of Drilling Holes Into The Plates - Use Silicon To Attach The Stand To The Plates. Special Network Of Channels In The Mount Body Allows The Silicon To Hold Very Strong To The Printed Pla Body. I Already Printed Similar Wall Mount For Oral B And It Was Really Hard To Remove It - So There Is Zero Chance The Mount To Unglue And Fall Down Accidentally. Before Gluing The Mount To The Ceramic Plates - Clean The Surface With Alcohol. Then Apply An Even Layer Of Silicon And Press Gently The Mount Until The Silicon Squeezes Away From The Side Holes. Remove The Excessive Silicon (Use A Cloth With Soap) And Fix The Mount For Couple Of Hours With Paper Tape. After The Silicon Settles Down - Remove The Paper Tape And Insert The Charger, It Should Fit And Snap Into The Hole. Ideally The Silicon Color Should Be The Same As The Gap Between The Plates (Transparent Silicon Leaves The Side Channels Of The Base Visible). The Filament Color Should Be Chosen According To The Plates. I Achieved The Best 3D Printing Results By Placing The Hole For The Charger On The 3D Printer Plate - Some More Filament Is Used For Supports But The Surface Finish Is The Best.
Statistics
Likes
14
Downloads
0