Sturdy Accessory Holder for Dyson V7 V8 V9 V10 V11
Description
Sturdy Accessory Holder For Dyson V7 / V8 / V9 / V10 / V11 Vacuums. (Dyson V6 Accessories Use A Different Connector And Will Not Fit.) Works Just Like The Factory Dual Accessory Holder That'S Built Into The Charging Station - Snap In Your Accessories From Underneath, And Release It Just Like You Were Removing The Tool From The Vacuum. The Intended Mounting Position Is Flat Side Up, With The Two Side Mounting Holes Above The Single Center Mounting Hole. With Some Good Wall Anchors, This Will Hold Even The Big Motorized Vacuum Heads. Designed To Be Friendly To Fdm Printers: * Integrated Custom Supports For Holes (Snaps Out With Minor Cleanup - No Slicer Supports Needed) * All Big Overhangs Are Less Than 20 Degrees Off Vertical * Only A Few Small Chamfers That Result In A Few Layers Of 45 Degree Overhangs * Large Surface Touching The Bed For Better Bed Adhesion This Design Was Inspired By [@Cornick'S](Https://Www.Thingiverse.Com/Cornick/About) [Dyson Attachment Storage](Https://Www.Thingiverse.Com/Thing:1127838) Design (Which Unfortunately Didn'T Fit My Attachments), So I'Ve Flagged This As A Remix.
Statistics
Likes
52
Downloads
0