Raise3d N2 Riser
Description
My Raise3D N2 Has Been Very Good To Me, But It Needs A Little Rise In The Lid Design To Clear The Bend In The Filament Tubes As They Enter The Extruder. I Use Mostly Pla, But Where The N2 Sits Is Near An Ac Duct And The N2 Needs The Lid. I Made These Risers To Sit On All 4 Corners And Bring The Plexiglas Lid Up About 30Mm. You May Want To Go A Little Bit Higher As The Filament Tubes Still Hit The Lid When It Goes Full Right. I Put Holes In The Riser So You Could Add Set Screws To Lock Them To The Main Enclosure, But The Riser Fits Tightly On The Main Enclosure, Such That I Didn'T Use Any. The Holes Are Sized To Allow Self Threading Standard 4-40 Machine Screw Into Them.
Statistics
Likes
12
Downloads
0