Rotating Table with 24BYJ-48 Stepper and 608 Bearings

Description

I Needed A Rotating Table For A While And Since I Had That Spare 24Byj-48 Stepper Motor And Controller On Hand (These Come With Various Arduino Starter Kits) And A Few 608 Bearings I Designed One For Myself. Since It Came Out Quite Good (Smooth Motion - Not Too Loud) I´D Like To Share It With You. The Assembly Is Pretty Self-Explanatory: Screw The Motor Into The Base (Cables Facing Downwards) Using Some Self Tapping Screws Around 3-4Mm (Be A Liitle Bit Careful With The Holes Since The Walls Are Quite Thin - Maybe I´Ll Rework Them). I Glued The Base_Ring_Cover To The Base - But It Will Work Without Glue Too. Insert 1 Bearing Into The Center Of The Table And 3 Into The Posts Using 3 Of The Pins - You Can Glue The Pins Or Just Leave Them As Is - That Is Far From Fast So They Shouldn´T Come Loose. If You Need The Table_Cover_Ring You Can Print It And Glue It To The Table. For Driving The Table You´Ve Got Two Choices: - Either Use The Spur_Gear And The Flat_Gear: Glue The Flat_Gear Onto The Lower Face Of The Table (Where The Bearing Are) - It Should Center Itself Around The Chamfer In The Middle. - Or Use Wheel And Tyre (The Tyre Needs To Be Some Flexible Material) For A Friction Drive. Why ? The Gears Will Make More Noise - The Wheel&Tyre Are Quite. I´M Talking Whispering Noise Levels Here. What´S Missing: Electronics Mount Below The Table - I´Ll Look Into This And Create A Bottom For The Base Which Will Be Able To Fit The Arduino, Stepper Driver And A Battery - But I Need Some Time To Source The Parts.

Statistics

Category

Tags