OrdBot Z Rod Stabiliser
Description
An Arm Which Attatchs The The Side Of The Z Makerslides. Holds A Standard Abec Bearing (Out Of Skateboard Etc) 22Mm Od, 8Mm Id, 7Mm H. Have To Replace The 8Mm Threaded Rod And Increase The Length To Maintain 150Mm Z Travel. I Cut The Rods To Match The Height Of The Makerslides. Used A Thin Layer Of Thin Tape To Ensure The Rod Sits Snug Within The Bearing Centre. Align The Z Motor Once The Bearings Are Installed. *Not Recommended Unless You Are Using A Floating Z Nut Modification (Z Wobble Stabiliser)*
Statistics
Likes
19
Downloads
0