Cat phone/tablet stand
Description
Little Cat To Hold A Phone Or Tablet While Charging. Cute For Halloween When Printed In Black. I Printed It Laying On Its Side With Supports For The Cord Holes. Update 8/22/20 I Have Cleaned Up The File The New One Is Phonecat3.5.Stl And Should Not Have The Layer Problems That The Old File Had. Other Than That The Design Is The Same. I Have Newer Software And A Newer 3D Printer Now And Can Definitely Print This Without Supports When Printed Laying Flat On It'S Side. I Have Also Redesigned The Entire Stand Now That I Have More Experience And Will Post It As A Separate Thing. The New One I Think Is A Much Better Design, But It Is Larger And Takes 14 Hours To Print. This One Only Takes 5 Hours, So There Is A Trade Off. New Version Https://Www.Thingiverse.Com/Thing:4576645
Statistics
Likes
190
Downloads
0