bed level helper for wanhao duplicator i3 (and plus)

Description

Two Versions Of A Very Basic Bed Leveler I Designed To Help With My Own Printer (An I3 Plus)... One With Text And The Other Plain. Hang Both Of These At Opposite Ends Of The Top X Axis Rod, And Slowly Bring Z Down Until One Or Both Of The Levelers Almost Touch The Bed. Adjust Your Bed To Make Sure It'S Level (Essentially, The Same Vertical Distance From The Bottom Of Both Levelers). Eyeballing The Distance Between Bed And Leveler Should Be Good, In Most Cases. Or, If There'S Just Not Much Available Range To The Screws, Adjust Your Z Axis Couplers And Then Adjust The Bed Leveling Screws. Bed Level Should Be Checked At The Minimum, At Each Of The Y Ends Of The Bed, And Optimally, Even At The Middle. Check Both Y Extents First, And Then The Middle. Adjust Leveling Screws As Necessary.

Statistics

Category

Tags