Razor RipStik Casterboard Wall Mount Rack
Description
This Rack Is Designed To Hold The Razor Ripstik Casterboard Horizontally Against A Wall. The Ripstik (Rip Stick, If You Misspell It) Is A Fun Scooter For My Kids, But I Was Tired Of Them Lying On The Floor In The Garage, So I Designed This Rack So That They Could Be Hung Up On The Wall. There Is A Rib In The Middle Of The Holder That Fits Into The Groove In The Ripstik, Centering It On The Rack. The Ripstik Can Point Either Way. I Did Find That The Center Of Gravity Is Slightly Off From The Groove, But The Holder Is Wide Enough It Stays Balanced On The Rack. Once Printed, Simply Screw Into The Wall Using Two Screws. The Ripstick Is Heavy Enough That You'Ll Need To Either Screw Into Studs Or Use Anchors Appropriate For Your Wall Type. I Printed Three Copies At 35% Infill Just To Be Safe And They Hold Quite Well. If You Print At 20% And It Works For You, Please Leave A Comment And I'Ll Update The Print Specs. This Is My First Model Posted To Thingiverse, So Constructive Feedback Is Welcome! *I Put A Lot Of Effort Into These Designs. Even A Small Tip Is Greatly Appreciated!*
Statistics
Likes
10
Downloads
0