Creality 3D CR10 Heat bed cable support and corner Guides for stock glass bed (Tight fit) No play on the corner parts.

Description

I Wasn'T Too Keen On Just The Heat Bed Cable Suport On One Corner It Looked Alone So I Made A Full Set Of Corner Pieces That Made As Little Contact On The Bottom Of The Heat Bed As Possible, They Also Help Stop The Springs Underneth Digging In To The Heat Bed Ovetime. 1X Heat Bed Support (With Cover) Need Two Small Zip Ties. 3X Corner Guides For The Stock Glass Bed With No Play (Wobble) In The Parts. They Will Fit And Hold The Glass Tight, Stopping It From Sliding Arount When The Clips Are Removed. They Help Gulide The Glass Bed In To Place, I Still Use The 4 Small Clips To Hold The Glass Flat Though, But My Glass Is Pretty Flat And I Have Forgotten To Add The Clips On Some Prints And They Have Turned Out Ok. Not Sure If The Ikea Mirror Will Fit As I Dont Have One. Please Note Z Endstop May Need Adjusting To Compensate For The 4Mm Difference In Spring Compression When Adding These, Depending On Your Set Up, Otherwise There Wont Be Sufficient Slack To Level The Bed.

Statistics

Category

Tags