Bill Cipher Figurine
Description
Painted And Glued Together Figurine Of 3D Bill Cipher From Gravity Falls. <B>Instructions - !Read The Readme!</B> These Files Are <B>Not</B> Ready To Print As Is. You <B>Will</B> Have To Measure All Objects Out Individually As To Fit Your Printer Configuration, Preferred Model Size And Tools At Hand. This Is A Diy Project That Will Require A Bit Of Attention. Tools You Will Need: <Ul> <Li>3D Printer (Duh) That Is Decently Calibrated And A Filament Fit For Small Detail</Li> <Li>Boxcutter, Pliers And Other Cutting Tools</Li> <Li>Some Kind Of Glue That Will Attach To Pla - A Hot Glue Gun Will Do Fine If You'Ve Got A Steady Hand</Li> <Li>Ruler/Measuring Tape Or A Keen Eye For Measurements</Li> <Li><I>Optional:</I> Paint - What I Used Here Is Hobby Laqueur, A "Promarker" And Acrylic</Li> <Li><I>Optional:</I> Double Sided Tape - Preferably Something Not Very Sticky</Li> </Ul> Depending On Your Printer, Calibration, Filament And Time At Hand You Will Have To Measure Out All Parts And Approximate It Based On Your Build. <Ul> <Li>Body: Pictured Is The Body Printed At 0.1 Or 0.2Mm Layer Height (I Forgot) At 60Mm Across X With 10% Infill. Scale It Up Or Down To Your Preference And Use It As A Baseline For The Rest Of The Pieces.</Li> <Li>Eye - The Eye Pictured Is 25Mm Across. I Printed A Whole Bunch Of Them, Scaling Them Up In 2Mm Increments, And 25Mm Is What Ended Up Working For Me, Though It Is A Little Bit Too Large For This Body. Smaller Eyes Did Come Out Okay In Quality, But I Ended Up Breaking Off A Few Of The Eyelashes When Trimming Some Of The Excess Plastic On The Smaller Ones. I Printed Mine At 0.06Mm Layer Height.</Li> <Li>Bowtie - The Pictured Bowtie Is 20Mm Across. If I Were To Make Another Model I Would Scale This Up To 25Mm On This Particular Scale Model. This Was Printed At 0.06Mm Layer Height.</Li> <Li>Arms And Legs - I Printed Both Of These At 40Mm In "Height", Layed Down Flat At 0.06Mm Layer Height, With Support Material And A Bit Of Plate Adhesion. I Had To Trim Off About 3-4Mm Of The Top Of The Legs With A Pair Of Sharp Pliers As They Were Modeled Too Long. A Fair Amount Of Cleaning Up Support Material Was Needed For These Pieces, As They Are A Bit Weird To Print, But The Result Looked Good Enough For Me.</Li>
Statistics
Likes
236
Downloads
0