Echo Dot Wall Mount
Description
I Printed This Out Of Abs And Yes It Shrunk So I Scaled Each Part By 1.50Mm In All Directions Its Not Perfect As The Cables Out The Side Of The Dot Are Close And End Up Being Buried In The Plasterboard. I Had To Relieve The Back Side Of The Plasterboard To Allow It To Fit. I Used A 92Mm Hole Saw Dont Bother With The Hole Fixings, I Ended Up Bonding It In Place (Not The Dot Jut The Bracket). My Advice Would Be To Trial A Fit On A Peice Of 12Mm/12.7Mm Plasterboard Before Committing Yourself To A Large Hole In Your Wall!!!!! I Also Spray Painted The Outer Ring Just So It Was Bright White. You May Also Have To To A Little Filling With Decorators Caulk As This One Has Straight Sides But It Is Very Minimal.
Statistics
Likes
1
Downloads
0