Prusa i3 Rework 1.5 (Emotion-Tech / reprap france) - Y belt tensioner system (complete)

Description

Just Reworked A Bit The Original Part. Now The Belt Of The Y Axis May Not Slip Away Of The Bearing'S Outer Surface. Mounting Procedure Is A Bit Less Simple Though, Requires To Get All Parts Approximately Put In Their Final Location For Them To Be Mounted Properly. This Set Of Parts Provides: - The Pulley (Mounted On The Outer Part Of The Bearing - 13 X 4 X 5 Mm [Outer Diameter X Inner Diameter X Thickness]) Note That This Pulley Should Be Printed In Two Halves And Then Glued Together With Superglue (Or Anything Else). - The Main Tensioner Body - Two Braces To Keep The Part In The Center Of The Tensioner. Hope This Will Improve A Bit Your Printing And Save Your Belts To Wear Out Too Quickly.

Statistics

Category

Tags